GW Instek AFG-3000 Series - Manual (Page 257)

REMOTE INTERFACE
257
Immediate A burst is output at a set
frequency determined by the burst
period.
External EXTernal will output a burst
waveform after each external
trigger pulse. Any additional
trigger pulse signals before the
end of the burst are ignored.
Manual Manual triggering will output a
burst waveform after the trigger
softkey is pressed.
Note If the APPLy command was used, the source is
automatically set to IMMediate.
The *OPC/*OPC? command/query can be used to
signal the end of the burst.
Syntax SOURce[1]:BURSt:TRIGger:SOURce
{IMMediate|EXTernal|MANual}
Example SOUR1:BURS:TRIG:SOUR EXT
Sets the burst trigger source to external.
Query Syntax SOURce[1]:BURSt:TRIGger:SOURce?
Return Parameter IMM Immediate
EXT External
MANual Manual
Example SOUR1:BURS:TRIG:SOUR?
IMM
The burst trigger source is set to immediate.
SOURce[1]:BURSt:TRIGger:DELay
Source Specific
Command
Description The DELay command is used to insert a delay (in
seconds) before a burst is output. The delay starts
after a trigger is received. The default delay is 0
seconds.