Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 87)

4-15
M-4659
Displaying Data with the Data V
iewer
1
2
3
4
5
6
7
8
Index
Displayed position: Center
Displayed position: Left
Displayed position: Right
Flag
If you left-click the mark while pressing the “Ctrl” key, the mark is displayed in front.
If you left-click the mark while pressing the “Shift” key, the mark is displayed in the back.
Double-clicking a mark, that has been created using the Data Viewer, opens the [Mark]
dialog box in which you can change the displayed group and the mark name.
Searching the Alarm Transition Point and Mark Position
Search the alarm transition point
Click one
Search the mark position
Click one
Searching the Alarm Transition Point
Moves Cursor A or Cursor B to the alarm transition point (the point at which the alarm
occurred and the point at which the alarm was released) of the active channel.
Searching is possible to the left and right of the cursor.
Searching the Mark Position
Moves Cursor A or Cursor B to the mark position (arbitrary mark or trigger mark) of the
active group.
Searching is possible to the left and right of the cursor.
Note
• The searching function cannot be used, if the cursor is not displayed.
• The search function cannot be used, if there are no arbitrary marks or when the alarm
display is OFF.
4.2 Displaying the Waveform