Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 241)

7-67
M-4659
1
2
3
4
5
6
7
8
Index
Configuring the CX1000/CX2000
7.11 Network Settings
To enter network settings, click the [Setup] tab, then select [Network] from the list on the
left. It is also possible to select the item in [SETUP [Basic] Setting] on the [Setting] menu.
TCP/IP Settings
Connect the CX to the Ethernet and, in the dialog box below, enter TCP/IP settings.
Type the same address for [IP Address] as the one of the [Address] box of the [Network
Settings] dialog box.
1. Click here. (Or choose the [Setting] menu - [SETUP [Basic] Setting] - [Comm].)
2. Click this tab
Specify the
IP address
Enter the timeout value when turned ON
Specify these
addresses when
using the DNS
Serial Communication Settings
When using serial communications between the CX and other devices, set the parameters
required for serial communications. If [MODBUS MASTER] is selected in the [Protocol]
settings, you must click the [Modbus master] tab and enter [Modbus master] settings.
Click this tab