Setting the y-axis – Yokogawa Data Acquisition with PID Control CX2000 User Manual
Page 80
4-8
M-4659
Setting the Y-axis
Selecting the waveform display zone
User zone
Edit zone
Full zone
Slide zone
Auto zone
Multi-axis zone
Waveform display limit
([Y-Axis] - [Clip])
Click one
([Y-Axis] - [User zone]/[Edit zone]/[Full zone]/
[Slide zone]/[Auto zone]/[Multi-axis zone])
Select from the following list of choices:
For the display examples of each zone, see the next page.
• User zone:
Each waveform is displayed in the range specified in [Zone] under
the [General Display Setting] (the zone cannot be changed on the
trend display screen).
• Edit zone:
Each waveform is displayed in the range specified in [Zone] under
the [General Display Setting] (the zone can be changed on the trend
display screen).
• Full zone:
Display all waveforms using full zones.
• Slide zone:
Display the waveforms in a cascade fashion from the top to the
bottom of the waveform display area.
• Auto zone:
Display the waveforms by equally dividing the waveform display area
by the number of displayed waveforms.
• Multi-axis zone: Display the Y-axis of multiple waveforms.
Note
If the waveform display zone is set to some setting other than multi-axis zone and auto zone,
only the Y-axis of the active waveform is displayed.
Examples of the Various Zone Settings
• Full zone
• Slide zone
Full zone
Slide zone
4.2 Displaying the Waveform