Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 13)

1-4
M-4659
1.4 Starting/Exiting the Utility Software
Starting
1. From the Start menu, select [Programs] - [DAQSTANDARD] - [Launcher].
Launcher starts, and the following window appears.
Menu bar
Hardware Configurator Start button
Data Viewer Start button
[Network] dialog box display button
After installing the software, when you first start it, the [Network] dialog box appears. For
details about the setting method, see section 2.3, “Setting the Communication Method”. If
the recorder is not turned ON or connected, the [Network] dialog box opens. Press Esc to
close the Network dialog box.
2. Click the start button of the desired utility, or select the desired utility from the
Launcher menu. [Hardware Configurator], [Data Viewer], and [Network Configuration]
appear on the [Launcher] menu.
Note
• Once Hardware Configurator, Data Viewer or [Network] dialog box has started, the
corresponding start button will be disabled until it is exited.
• If you want to open a single Data Viewer, select [Program] - [DAQSTANDARD] - [Viewer].
• Once Hardware Configurator has started, it is not possible to open the [Network] dialog box.
• Once the [Network] dialog box is opened, it is not possible to start Hardware Configurator
and Data Viewer.
Exiting
To exit Hardware Configurator or Data Viewer, select [File] - [Exit], or click the [X] button.
To exit the [Network] dialog box, click [OK], [Cancel] or [X] button.
To exit Launcher, select [Launcher] - [Exit], or click the [X] button.
Note
• Before exiting Launcher, make sure that all the utilities are exited.
• When Launcher is exited, the DAQSTANDARD will also be exited.