Yokogawa Data Acquisition with PID Control CX2000 User Manual
Page 190
7-16
M-4659
[Parameter Address Setting] Tab
Select the parameter address settings from the following ranges.
30001 to 39999, 300001 to 365535, 40001 to 49999, 400001 to 465535.
[Tuning Setting] Tab
• Tuning Setting
Tuning item ON/OFF
Select [On] for the parameters that you want to display in the tuning window, and [Off]
for other parameters.
ID
Select the ID of the item from the choices below.
Internal Loop
SP (target set point), A1 (alarm 1 setting), A2 (alarm 2 setting), A3 (alarm 3 setting),
A4 (alarm 4 setting), P (proportional range), I (integration time), D (differentiation
time), OH (upper output limit), OL (lower output limit), MR (manual reset), H (hysteresis),
DR (control action direction), DB (dead band), PO (preset output), ETC (others), BS1
(measured value 1 input bias), FL1 (measured value 1 input filter), BS2 (measured
value 2 input bias), FL2 (measured value 2 input filter), RT (ratio setting), RBS (remote
input bias), RFL (remote input filter), or W01-W36 (control computation constant)
7.3 Control Function Basic Settings