Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 273)

8-23
M-4659
1
2
3
4
5
6
7
8
Index
Configuring the DX100/DX200/DX200C/MV100/MV200
Network
Setting the TCP/IP
1. Click here (also selectable from [Setting] - [SETUP [Basic] Setting]-[Comm])
2. Select this tab
Set the IP
address
Enter the timeout value when
turned ON
Set these
addresses when
using the DNS
In the case of a CONFIG file, the IP address cannot be configured.
When communicating with the DX100/DX200/MV100/MV200 via Ethernet, the IP
address, subnet mask, and default gateway must be set on the DX100/DX200/MV100/
MV200 beforehand.
Setting the FTP
2. Select the primary or secondary tab.
1. Select this tab.
Select the file
transfer
destination
By using the FTP function, you can automatically transfer the measured/computed data
files to the specified server.
8.5 Configuring the Setup Mode