Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 179)

7-5
M-4659
1
2
3
4
5
6
7
8
Index
Configuring the CX1000/CX2000
7.2 Setting and Checking the System Configuration
and Initializing Setup Data
Entering and Checking System Settings
You can create new setup data files or open existing setup data files, and then enter or
check system configuration according to the connected CX specifications.
Normally these settings should be entered per the specifications of the CX being setup.
2. The [System Configuration] dialog box opens.
Click the [CX] tab.
1. Select [System Configuration]
on the [System] menu.
You can enter the following settings in this dialog box.
Type
Select either CX2000 or CX1000.
Channel
Select the number of channels of the CX.
CX1000: 0 (when set to Style 2 or later), or 6 channels
CX2000: 0 (when set to Style 2 or later), 10, or 20 channels
LOOP
Select the number of loops.
CX1000: [0LOOP], [2LOOP]
CX2000: [0LOOP], [2LOOP], [4LOOP], [6LOOP]
Style
Select the CX style number.
Math Function
Select whether or not to enable the math functions (computation function).
Serial
Select the serial communications mode from [OFF], [RS-232], or [RS-422/485].
Media
Select the external storage media from [FDD], [ATA], or [ZIP].