Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 277)

8-27
M-4659
1
2
3
4
5
6
7
8
Index
Configuring the DX100/DX200/DX200C/MV100/MV200
8.7 Sending the Setup Data to the DX/MV
The setup data are sent when
[Comm] - [Send] is selected.
A confirmation dialog box is displayed.
To send the new setup data to the DX100/DX200/DX200C/MV100/MV200, click the [OK]
button.
If the DX100/DX200/DX200C/MV100/MV200 is acquiring data to the memory, a message
“Now Memory & Math sampling. Can’t store setting” is displayed. The data will not be
sent in this case.
Note
Of the network settings in the [Setup] tab, the following items are not transmitted.
• [IP Address] under the [TCP/IP] tab
• All settings under the [Serial] tab