Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 211)

7-37
M-4659
1
2
3
4
5
6
7
8
Index
Configuring the CX1000/CX2000
Program Pattern Setting (Segment setting)
You can enter a program pattern for each segment. Set the program patterns by clicking
the [Program pattern] tab, then selecting [Segment settings].
Select the pattern number
Select the segment number
Initialize the program pattern
Segment setting
Insert a segment before the selected segment
Add a segment behind the last segment
Delete the selected segment
Expand/reduce the selected segment along the time axis
Display the time axis per the segment time ratio
Display program patterns together
Split-display the program pattern at each loop
Start value and target value display ON/OFF
Select current loop
PV event display
Drag the bar
to change the
display area
Maximum value
for target setpoints
Segment number
Target setpoint for
selected segment
Time event display
Duration of segment
Start value for selected segment
Minimum value for target setpoints
Drag the bar
to change the
display area
7.6 Program Control Related Setup Operations