Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 251)

8-1
M-4659
1
2
3
4
5
6
7
8
Index
Configuring the DX100/DX200/DX200C/MV100/MV200
Chapter 8 Configuring the DX100/DX200/DX200C/MV100/MV200
8.1 Starting the Configurator
The Configurator can transmit and receive the setup data, change the setup data, and
create new setup data. It can configure the following style numbers of DX and MV. The
setting screen may differ from your actual screen.
DX100
DX200
DX200C
MV100
MV200
DX/MV
(Style Number)
Style1 Style2 Style3 Style4
(S1) (S2) (S3) (S4)
Starting the Hardware Configurator
1. Double-click here.
2. The DX/MV
Configurator opens.
Print (section 8.10)
Data check (section 8.6)
Display the version information of the Configurator
Scroll the screen (left and right)
Menu bar
Toolbar
Scroll the
screen
(up and down)
New file (section 8.1)
File open (section 8.1)
Save (section 8.9)
Recieve (section 8.1)
Send (section 8.7)
3. The DX2000 setting screen appears by default.
Carry out the procedure in pages 8-2 and 8-3 to
switch to the DX/MV setting screen.
Note
The [Control Settings] menu is not used on this recorder. The explanations in this chapter are
given using windows without [Control Settings].