Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 276)

8-26
M-4659
8.6 Adjusting the Setup Data (Checking the Data)
2. If the data are not consistent,
the following dialog box opens.
1. Click here ([System] - [Data Adjustment]).
Click here to display the correction list
Checks whether or not the specified setup is consistent with the actual system. If it is
not, the data are automatically corrected.
The data are corrected in the following cases:
• When the values of the items of the Meas/Math tab are outside the range.
• When an invalid character string is used
Data adjustment dialog box
If [View] - [Data Adjustment Dialog Box] is checked, the [Data Adjustment] dialog box will
open when the data are not consistent at the time of the data check or at the time of data
transmission.
Note
Perform the data check before sending the new setup data to the DX100/DX200/MV100/
Mv200.