Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 209)

7-35
M-4659
1
2
3
4
5
6
7
8
Index
Configuring the CX1000/CX2000
Initial Program Patterns
You can set the initial program patterns. You can set the initial (default) program patterns
by clicking the [Program pattern] tab, then selecting [Default setting]. Settings cannot be
entered when the number of segments is 0. Add segments using [Segment setting].
Set the start code
Available when segments have been inserted or added under [Segment setting].
Set the start setpoint
Available when segments have been inserted or added under [Segment setting].
Copy the settings (Default setting/Segment setting)
Paste copied pattern settings (Default setting/Segment setting)
Select the pattern number
Pattern Default setting
Pattern name, Setting method, Start setpoint, Start code
Enter a pattern name setting
Segment setting
Program pattern, PV Event, Time Event, Repeat
Event output setting
AUX setting
Automatic message printout, program display position
Event display group setting
Click this tab
Segment and event totals
(cannot be set here)
The number of segments
and events used with
this pattern.
(cannot be set here)
Set the segment setting
method
Zone number
Wait setting
Available when segments
have been inserted or
added under
[Segment setting].
Wait time setting
PV event hysteresis settings
Set the operating loop
Pattern number
Select the number of the desired pattern from [1] to [30] ([1] to [4] for models with /PG1
option).
Pattern name
Enter the pattern name using up to 16 alphanumeric characters.
Segment setting method
Select segment time setting method or segment time ramp grade setting method. If you
change this setting, the program pattern setting corresponding to the pattern number is
initialized.
Start target setpoint
Set the start SP, a starting condition, in the range of [EU (0.0% to 100.0%)] (initial value
is 0%) of the measurement span. For style 3 or later, the PV event hysteresis setting for
loops turned ON in operating loop designation can be entered. With style 2 or earlier,
settings for loops turned ON in Program Control under Internal Loops in the Setup tab
can be entered. Only the loops that are set as follows are displayed: [Setup] tab > [Internal
Loop] > [Program control] to [On]. During cascade control, even-numbered loops within
the same terminal block are not displayed.
7.6 Program Control Related Setup Operations