Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 61)

3-45
M-4659
Configuring the DX1000/DX2000
1
2
3
4
5
6
7
8
Index
E-mail
Set the SMTP server and mail address.
• SMTP server name
Enter the host name or IP address of the SMTP server.
• Port No.
Unless specified otherwise, set the number to the default value. The default value is
25.
• Address 1, Address 2
Enter the e-mail address. Multiple e-mail addresses can be entered in the box of one
recipient. When entering multiple addresses, delimit each address with a space. Up
to 150 characters can be entered.
• Sender
Enter the sender e-mail address. You can enter up to 64 characters.
Alarm
Specify the settings for sending e-mail when alarms occur.
• Recipient1 and Recipient2
Set the e-mail recipients. For Recipient1 and Recipient2, select [ON] to send e-mail
or [OFF] to not send e-mail.
• Active alarms
Sends an e-mail when an alarm occurs. You can select [ON] (send e-mail) or [OFF] (not
send e-mail) for alarms 1 to 4.
• Include INST
Select [ON] to attach instantaneous value data when the alarm occurred.
• Include source URL
Select [ON] to attach the source URL. Attach the URL when the Web server is
enabled.
• Subject
Enter the subject of the e-mail using up to 32 alphanumeric characters. The default
setting is Alarm_summary.
• Header1, Header2
Enter header 1 and header 2 using up to 64 characters.
3.6 Entering Basic Settings