Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 180)

7-6
M-4659
Alarm Relay
Select the type of alarm relay from [NONE], [4p+With Fail/Mem. End], [6p], or [External
Loop]. If you select 2LOOP for the CX1000, the Alarm Relay is automatically set to
[NONE]. The items that can be selected vary depending on the model, number of
channels, and number of loops.
If you select [2LOOP] for the CX1000, the [Alarm Relay] is automatically set to [NONE].
Options
If set to a style before Style 2, the following options can be selected.
• Green Series Comm
Select whether options are installed for communications with an external controller.
This option can only be selected when [Serial] is set to [RS-232] or [RS-422/485].
Also, this option is fixed to [Green Series Comm] if [0LOOP] is selected.
• Ladder Comm
Select whether a ladder communication option is installed. This option can only be
selected when [Serial] is set to [RS-232] or [RS-422/485].
Also, this option is not available if [0LOOP] is selected.
Remote
Select whether a remote option is installed. Note that this option can only be selected
when [Alarm Relay] is set to [4p+With fail/Mem. End] or [6p].
Batch
Select whether a batch option is installed. This option applies to style number S3 or later.
Program
Select [None], [Program Num:4], or [Program Num:30].
When you change the system configuration and click the [OK] button, the “System
configuration has been changed. The input configuration and data will be initialized.
Continue?” message appears. Click the [OK] button to initialize the data.
Initializing the Setup Data
2. The [Initialize]
dialog box opens.
1. Select [Initialize] on the [Setting] menu.
3. Click to complete
the initialization.
7.2 Setting and Checking the System Configuration and Initializing Setup Data