Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 125)

6-10
M-4659
Moving Average
To use the moving average, select the sampling count [Times] (2 to 400).
Tag
Up to 16 characters can be entered for the tag.
You can use the tag name instead of the channel number to be displayed on the screen.
This can be selected when [Tag] is [Tag] under [Detail Setting] in the [Basic Setting] tab.
Memory Sampling
Turn [ON] (sample) or [OFF] (do not sample).
Display Zone (Zone L and U)
You can select the range of the screen in which the waveform of each channel is to be
displayed.
Specify positions (%) on the display scale for the upper and lower limits.
The conditions for setting the zones are as follows:
• Range: 0% to 100%
The lower limit L must be less than the upper limit
• The difference between the lower and upper limits is at least 5%.
Graph
For details, see section 5.7 in the RD-MV1000/RD-MV2000 User’s Manual (IM RD-
MV1000-01E).
Scale display position
Select the scale display position on the trend display from 1 to 10 for the RD-MV2000 or
from 1 to 6 for the RD-MV1000. Select [OFF] if you do not wish to display the scale.
Scale divide position
Select the number of main scale marks on the trend display from 4 to 12 and C10.
C10: The scale is equally divided into 10 sections by main scale marks, and scale
values are indicated at 0, 30, 50, 70, and 100% positions on the trend display.
Bar display position
Select [Normal], [Center], [Lower], or [Upper].
Bar divide number
Select number of divisions of the scale on the bar graph display.
6.3 Setting the Measurement Channels, Ext. Channels