Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 108)

4-36
M-4659
4.12 Converting the Data
1. Select one.
2. The [Conversion Details] dialog box opens.
When Viewing the Trend Display or Digital Display
5. Change the save
destination.
3. Enter the conversion range.
4. Select either one.
Save destination and file name
When Displaying a TLOG File
3. Select the timer numbers to be converted.
4. Change the save
destination.
The measured data can be converted to ASCII, Lotus, and Excel formats.
Start Point and End Point
Cursor A and Cursor B are used to set the start point and end point of the range,
respectively. If Cursor A and Cursor B are not specified or the cursors were erased, the
data numbers of the start and end points are automatically set to [0] and [total number of
data points - 1], respectively.
To convert all the data in the specified range, set the step number to 1.
Step
To convert all the data in the specified range, set the step number to 1.
Group/Channel
If you select [Group], enter the range of groups to be converted.
If you select [Channel], enter the range of channels to be converted.