Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 275)

8-25
M-4659
1
2
3
4
5
6
7
8
Index
Configuring the DX100/DX200/DX200C/MV100/MV200
8.5 Configuring the Setup Mode
Setting the E-mail (style number S4)
Transmit e-mail message when creating a
report
Time of transmission
Alarm information
Transmit e-mail message when a system error occurs
• SMTP server name
Set the SMTP server name (up to 64 alphanumeric characters) or the IP address of
the SMTP server.
• Port number
Set the port number to use. The default value is [25].
• Recipient
Set the transmission destination of the e-mail message using up to 150 alphanumeric
characters. You can specify multiple addresses. To specify multiple addresses,
delimit the addresses using spaces.
• Sender
Set the e-mail address using up to 64 alphanumeric characters. If the address is not
set, the first address set in the recipient box is used as the sender’s address instead.
• Alarm
Transmits an e-mail messages when alarm is active/released.
• Scheduled
Transmits an e-mail message when the specified time is reached.
• System
Transmits an e-mail message during recovery from a power failure, when memory end
is detected, or when an error related to the external storage medium and FTP client
occurs
• Report
Transmits an e-mail message when report is created (only on models with the optional
computation function (/M1)
• Subject, Header1, Header2
Subject: Set the subject of the e-mail message using up to 32 alphanumeric
characters.
Header1 and Header2: Set the string to be attached to the e-mail message using up
to 64 alphanumeric characters.