Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 12)

1-3
M-4659
1
2
3
4
5
6
7
8
Index
Before using the DAQST
ANDARD
1.3 Installing the DAQSTANDARD
The DAQSTANDARD is provided by a CD-ROM. To install the software, an appropriate
serial number needs to be entered. The serial number is indicated on the CD.
Operating Method
1. Start Windows. Log onto Windows as an administrator.
2. Insert the CD into the CD-ROM drive of the computer.
3. The installation program starts automatically. Follow the instructions on the
screen to proceed with the installation.
If the installation program does not start automatically when you insert the CD-
ROM into the CD-ROM drive, use the following procedure to start it.
4. In [My Computer], double-click the CD-ROM icon.
5. Double-click the setup.exe file in the root directory. Installation starts. Follow the
instructions on the screen to complete the installation.
Note
• Before starting installation, make sure that all the resident programs such as anti-virus
programs are exited.
• When installation is complete, Launcher and Data Viewer will be registered to the Start
menu.
• To re-install the software, first uninstall it, then re-install it.
• To uninstall the software, follow the procedure given below.
1. In the [Control Panel], double-click [Add/Remove Programs]. The [Add/Remove
Programs Properties] dialog box will appear. From the list, select [DAQSTANDARD] and
uninstall it.
2. If necessary, back up the following files to another directory.
• Setup data file (*.pdl) saved under the directory where the DAQSTANDARD has been
installed
3. From Windows Explore, delete all the files (data files and subdirectories) created after
installation as well as the directory where the software was installed.