Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 51)

3-35
M-4659
Configuring the DX1000/DX2000
1
2
3
4
5
6
7
8
Index
Report
Click to display the channel selection screen.
Channel selection screen
Click the channel you wish to set up
Report kind
Select the type of report to be created.
Settings Description
OFF Do not create a report.
Hour Creates hourly reports.
Day Creates daily reports.
Hour+Day Creates hourly and daily reports.
Day+Week Creates daily and weekly reports.
Day+Month Creates daily and monthly reports.
Day, Week day, and Time (hour)
Set the date or day of the week and the time when the report is to be created. The
specified date/time is when the report file is divided. Set the values in the range
indicated below. Items with a dash are invalid.
Report Type Day Week day Time
Hour - - 0 to 23
Day 1 to 28* - 0 to 23
Hour+Day - - 0 to 23
Day+Week - SUN to SAT 0 to 23
Day+Month 1 to 28* - 0 to 23
* You cannot specify 29, 30, or 31.
Report Channel No.
The report is output in order by this number.
Use
Select [ON] for the report channels to be used.
CH No.
Set the channel to assign to the report channel. All channels can be assigned, but
reports are not created for channels set to [Skip] or [OFF] even if they are assigned.
Sum Scale
Set the sum scale to [/s] to [/day] to match the unit of the measured value.
Example: If the unit of the measured value is “m
3 /min,” select [/min].
OFF Sums as-is the measured data per scan interval.
3.6 Entering Basic Settings