Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 143)

6-28
M-4659
Event Date
Event related settings are enabled when [Data Kind] is set to [E+D] or [Event] in [Basic
Environment] under [Environment] in the [Basic Setting] tab.
Sample rate
Select the data recording interval from the available settings. You cannot specify a
sampling rate that is faster than the scan interval.
Mode
Settings Description
Free Records data continuously.
Single Records data when the trigger condition is met.
Repeat Records data each time the trigger condition is met.
Data length
Select the size of a record data file. The recorded data is divided by the file size
specified here. The available data lengths vary depending on the Sample rate setting.
Sample rate
Selectable range
of data length
Sample rate
Selectable range
of data length
Sample rate
Selectable range
of data length
* Selectable on the MV1004, MV1008 and MV2008
25 ms* 25 ms 250 ms 500 ms 1 s
10 min to 10 min to 10 min to 10 min to 10 min to
4 hours 1 day 2 days 3 days 7 days
2 s 5 s 10 s 30 s 1 min
10 min to 10 min to 10 min to 1 hour to 1 hour to
14 days 31 days 31 days 31 days 31 days
2 min 5 min 10 min
1 hour to 1 hour to 1 hour to
31 days 31 days 31 days
Pre-Trigger
Specify the range when recording data before the trigger condition is met. Select the
range as a percentage of the data length from 0, 5, 25, 50, 75, 95, and 100%. If you do
not want to record the data existing before the trigger condition is met, select 0%.
Trigger Signal Key
Select [ON] if you want to activate the trigger using key operation.
6.5 Entering General Settings