Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 10)

1-1
M-4659
1
2
3
4
5
6
7
8
Index
Before using the DAQST
ANDARD
Chapter 1 Before using the DAQSTANDARD
1.1 Overview of the DAQSTANDARD
The DAQSTANDARD consists of the following three utility programs.
• Launcher
• Hardware Configurator
• Data Viewer
Launcher
Launcher is provided to start the last two utility programs. It also allows you to set
communication conditions between the recorder and this DAQSTANDARD. Launcher
and Data Viewer will be automatically registered to the Start menu of Windows when the
DAQSTANDARD is installed.
Hardware Configurator
Allows you to set the recorder hardware (measurement/math channels, display method
etc.). It also allows transfer of the setup data to the recorder and saving it to the personal
computer’s hard disk. Setup data can be set by the following three methods.
• Receiving the setup data from the recorder currently connected to the PC
• Loading existing setup data
• By configuring a system
Data Viewer
Displays the following four types of data generated by the recorder and prints them. The
data can be displayed graphically or digitally.
• Display data file
• Event data file
• TLOG file
• Report file
• Manual sampled data file
Note
If you want to open a single Data Viewer, select [Program] - [DAQSTANDARD] - [Viewer].