Teledyne LeCroy SierraFC M8-4 User Manual - Manual (Page 33)

SierraFC M8‐4 Protocol Analyzer User Manual 33
Easy Mode (Pre‐Defined Setups) Teledyne LeCroy
Auto Run
Checking the Auto Run option allows you to specify the number of concurrent runs that
will be automatically carried out. (See
“Auto Run” on page 166 .)
Training Signal Pack Mode
This options provides two modes for training signals.
 Unpacked
 Packed
Last Captured Trace File
Browse to the location to upload the last captured trace file. Alternatively check the box
to use the Upload Manager.
Analyzer Settings
You can enable the ports, set the port speed and disable descrambling.
Disabling a port can be used to save recording buffer space. A disabled port can still
trigger the analyzer.
Auto Speed is the default port speed selection. It will automatically detect and display the
line speed. In rare cases (such as debugging speed negotiation), it might be desired to set
the analyzers speed manually. Note, that when the speed is set manually, traffic at
different speeds will not be captured correctly.
Set Protocol Error Detection
You can select which Protocol Errors the analyzer will show and which will be ignored.
Project Overview
The Project Overview on the right side of the main window displays a comprehensive tree
structured overview of the project. The project tree shows what to capture, on what the
analyzer triggers, and the capture memory settings.
Capture Tab
The Capture tab allows you to set the parameters for capturing patterns. The Capture
dialog box opens with default settings to capture Everything on the bus. The analyzer
captures everything immediately without triggering on anything in particular.
You can drag and drop patterns from the Patterns Library pane into the Active Pane. You
can select the pattern and use the Add and Remove arrows to move patterns between
the Patterns Library and the Active pane. You can copy and sort the patterns.
Truncate Payload
Check this option to truncate payload after x‐number of Dword(s).