Teledyne LeCroy SierraFC M8-4 User Manual - Manual (Page 320)

Teledyne LeCroy Scenario Batch Files
320 SierraFC M8‐4 Protocol Analyzer User Manual
Note: You can use a Label and a Goto Label to make loops. First make the label, then make Goto Label.
The Command Parameters window shows only enabled Labels.
Run
Runs the Scenario on hardware on specified ports. If you call this command for the first
time and the Scenario was not assigned to the hardware and ports before, the Scenario is
assigned to specified hardware and ports and then Scenario runs on the hardware.
Format
Run(Serial Number, Scenario Name, Responder Port)
Parameters
 Serial Number: Serial number of hardware
 Scenario Name: Name of Scenario
 PortMap: Port number in port map
Example
Run (ox841200," Substitute address frame", 4)
Beep(800, 400)
Run (ox841200," CRC Inject _ Play CD", 8)
WaitForStop(0x63463, 1, 150)
Run (ox841200," Remove Send Cue Sheet", 2)
Goto Label6
Run (S/N: 12871, Port 1, DISCOVER)
Note: If the selected ports are busy, Scenario cannot run, and the command will be skipped. The result
will be written in the Log area.