Teledyne LeCroy SierraFC M8-4 User Manual - Manual (Page 146)

Teledyne LeCroy Easy Mode (Pre‐Defined Setups)
146 SierraFC M8‐4 Protocol Analyzer User Manual
When data capture starts with Don’t care (Snapshot) selected, the analyzer triggers on
the first data pattern on the bus.
Starting a data capture with Pattern selected triggers when specific pattern(s) are
detected in the captured data stream. The following three ways can trigger the analyzer
with Pattern selected:
 Trigger on any pattern (Any Trigger Mode)
 External Trigger
 Trigger on a sequence of patterns (Sequential Trigger Mode)
Snapshot Mode
To trigger immediately on any pattern, check the Snapshot button.
Figure 2.115: Default Trigger Snapshot Mode Selected