Teledyne LeCroy SierraFC M8-4 User Manual - Manual (Page 162)

Teledyne LeCroy Easy Mode (Pre‐Defined Setups)
162 SierraFC M8‐4 Protocol Analyzer User Manual
Protocol Errors
See “Protocol Errors” on page 145 for more information.
Sequential Trigger Mode
In Sequential Trigger mode, triggering occurs whenever the system detects a specific
sequence of patterns. Defining the triggering patterns sets the sequence order. You must
define at least two patterns to enable selection of Sequential Trigger mode.
Note: Patterns, such as Primitives and Symbols or Frames, occurring very close together on different
ports, cause an error in triggering.
To define a triggering sequence, select more than one pattern, then check the Use
selected patterns in a sequence check box.
Figure 2.122: Select Sequential Trigger Mode
Timer
See
“Timer” on page 152 for more information.
Defining Patterns
The definition of patterns for the sequential trigger mode is identical to the Pattern
mode, with the following exception:
In sequential triggering mode, all the pattern dialogs display the option for setting to
count the expected number of occurrences on each link. This allows you to specify the