Teledyne LeCroy SierraFC M8-4 User Manual - Manual (Page 21)

SierraFC M8‐4 Protocol Analyzer User Manual 21
Expandability Teledyne LeCroy
Figure 1.15: Select Device Dialog Displaying Unit 1 and Unit 2 Chained
Note: When using STX Sync cards, you need to manually specify the order of the chained units. To
match your unit sequence to the address for each unit in the Select Device dialog, click the
pull down tab under the Order heading (on the right side) and select unit numbers: 1 for
Unit 1, 2 for Unit 2, and so on. This determines the order in which the cascaded ports appear in
the trace. When using the CATC Sync cards the order is automatically detected.
IMPORTANT! Power up all units before starting the software.
Removing Expansion Cards
You can remove expansion cards using two tools:
 Standard (flat blade) 3/16” screwdriver
 Teledyne LeCroy Extraction Tool (part number 230‐0160‐00
To remove an expansion card, follow these steps:
1. Unplug the system from AC power and turn the system so the expansion port is
facing you. Note the two retaining screws and the holes for the extraction tool that
are located on the panel of the expansion card.