Teledyne LeCroy SierraFC M8-4 User Manual - Manual (Page 31)

SierraFC M8‐4 Protocol Analyzer User Manual 31
Chapter 2
Protocol Analysis
The system performs Protocol Analysis by defining and running an analysis project. An
analysis project definition defines what to capture, what the analyzer triggers on, and the
memory settings. You can save defined projects as project *.fcc files for later use.
Supported Protocols
The supported protocols are listed below:
 FCP
 ARB
 ELS
 GS
 SW
 FICON
 FCAE‐ASM
 FCAE‐1553
 FCAE‐RDMA
 FCVI
 FCAV
 ADVB
 VSAN
Easy Mode (Pre-Defined Setups)
After you install the Analyzer software (see “Software Installation” on page 14 ) and set up
the Analyzer (see “Hardware Setup” on page 15 ), launch the Analyzer software (see
“Launching Your Analyzer” on page 26 ) to display the default Protocol Analyzer in Easy
Mode at the Capture tab.
This mode allows you to operate the analyzer with minimum setup. In this mode, you can
perform only a Trigger and Data capture.
Main Window
Use Easy Mode to get a comprehensive overview of your analyzer’s capabilities:
On the Analyzer Menu Bar, click File > Protocol Analyzer to open a Protocol Analyzer
dialog.