Port configuration – Teledyne LeCroy SierraFC M8-4 User Manual User Manual
Page 238
Teledyne LeCroy
Port Configuration
238
SierraFC M8‐4 Protocol Analyzer User Manual
Viewer Settings
Check the Wrap Packet box to enable the wrapping of packets in the display.
Check the Enable Tooltip box to enable tool tips for packet fields.
Data Payload
To change the length of byte fields displayed, select from the drop‐down list to display in
the Columns in Row and Bytes in Column box.
Time Stamp Origin
Check Absolute Trig to display trigger in real time. If left unchecked, the trigger position is
t=0 with samples before trigger shown as a (‐) number and after trigger as a (+) number,
or check Trigger, User Defined, Based on System Time.
Same color for start time and port
Check the appropriate Time Stamp Format and Time Format.
Save/Load Settings
You can save the customized configuration settings in a *.cfg file by clicking the Save
button and completing the Save As procedure. To load a previously saved configuration
file, click Load and choose an appropriate file.
Port Configuration
Port Configuration allows you to configure the ports for the Analyzer and Jammer and
the sequence in which they are attached.
To view and configure the ports, select Configuration > Port Configuration.
Figure 3.69: Set Port Configuration Dialog
Select a configuration from the drop down list in the Ports Assignment column and click
OK. See
.