Teledyne LeCroy SierraFC M8-4 User Manual - Manual (Page 278)

Teledyne LeCroy Settings in Advanced Mode
278 SierraFC M8‐4 Protocol Analyzer User Manual
As described later in this chapter, you can create any number of Scenarios and store them
in libraries on the PC hard drive. Scenario library files names are in the following format:
.ifc
VSAN RDMA FCP Command
Frame Information Unit
With Target Notification Refer to section “VSAN FCAE RDMA FCP Command Frame
Information Unit With Target Notification” on page 136.
VSAN FCAE‐RDMA FCP SCSI
Command ‐ Without Target
Notification Refer to section “VSAN FCAE‐RDMA FCP SCSI Command ‐
Without Target Notification” on page 137 .
VSAN RDMA FCP Frame
Information Unit Without
Target Notification Refer to section “VSAN FCAE RDMA FCP Frame Information
Unit Without Target Notification” on page 138 .
FCVI
VSAN‐FCVI(Any)
Refer to section “VSAN‐FCVI(Any)” on page 139.
VSAN‐FCVI(SEND_RQST) Refer to section “VSAN‐FCVI(SEND_RQST)” on page 139.
VSAN‐FCVI(WRITE_RQST) Refer to section “VSAN‐FCVI(WRITE_RQST)” on page 139.
VSAN‐FCVI(READ_RQST) Refer to section “VSAN‐FCVI(READ_RQST)” on page 139.
VSAN‐FCVI(SEND_RESP) Refer to section “VSAN‐FCVI(SEND_RESP)” on page 139.
VSAN‐FCVI(WRITE_RESP) Refer to section “VSAN‐FCVI(WRITE_RESP)” on page 139.
VSAN‐FCVI(READ_RESP) Refer to section “VSAN‐FCVI(READ_RESP)” on page 139.
VSAN‐FCVI(CONNECT_RQST) Refer to section “VSAN‐FCVI(CONNECT_RQST)” on
page 139.
VSAN‐
FCVI(DISCONNECT_RQST) Refer to section “VSAN‐FCVI(DISCONNECT_RQST)” on
page 139.
VSAN‐
FCVI(CONNECT_RESP1) Refer to section “VSAN‐FCVI(CONNECT_RESP1)” on
page 139.
VSAN‐
FCVI(CONNECT_RESP2) Refer to section “VSAN‐FCVI(CONNECT_RESP2)” on
page 139.
VSAN‐
FCVI(CONNECT_RESP3) Refer to section “VSAN‐FCVI(CONNECT_RESP3)” on
page 139.
VSAN‐
FCVI(DISCONNECT_RESP) Refer to section “VSAN‐FCVI(DISCONNECT_RESP)” on
page 139.
FCAV
VSAN‐FCAV(Simple)
Refer to section “VSAN‐FCAV(Simple)” on page 140.
VSAN‐FCAV(Extended) Refer to section “VSAN‐FCAV(Extended)” on page 140.
ADVB
ADVB(Object0)
Refer to section “ADVB(Object0)” on page 90.
ADVB(Objec2/3) Refer to section “ADVB(Object2/3)” on page 97.
Custom Frame Refer to section “Custom Frame” on page 143 .
Protocol Errors Refer to section “Protocol Errors” on page 145 .
Event Description