beautypg.com

Getting started manual – Teledyne LeCroy WaveRunner 6 Zi and 12-Bit HRO Getting Started Manual User Manual

Page 93

background image

Getting Started Manual

922136-00 Rev A

85

B

3. Touch inside the Grid Intensity data entry control.

4. Provide a value from 0 to 100 (percent).

5. Touch the Grid on top checkbox if you want to superimpose the grid

over the waveform.

Note

: Depending on the grid intensity, some of your waveforms may be

hidden from view when the grid is placed on top. To undo, simply uncheck

Grid on top

.

6. Touch the Axis labels checkbox to permanently display the values of

the top and bottom grid lines (calculated from volts/div) and the
extreme left and right grid lines (calculated from the timebase).

7. Choose a line style for your trace: solid Line or Points.

8. Touch inside the trace Intensity data entry control if you want to

change the value.

9. Enter a value from 0 to 100.

Note

: Access the Monitor tab for external monitor display settings. Refer to the

External Display

topic for more details.

S

EQUENCE

M

ODE

D

ISPLAY

Set up a Sequence Mode display by first selecting a Sequence trigger mode
in the Timebase → Horizontal Setup dialog. You must also have entered a
Num Segments value. For more information on setting up Sequence Mode,
see the Sequence Sampling Mode

(on

page 53

)

topic.

1. Touch Display → Display Setup... on the menu bar.

2. Touch inside the Display Mode control and select a display mode

from the pop-up menu.

Touch inside the Num seg displayed control and enter a value, using
the pop-up keypad.

Touch inside the Starting at control and enter a value.