Vertical, Overview, Channel controls – Teledyne LeCroy WaveRunner 6 Zi and 12-Bit HRO Getting Started Manual User Manual
Page 69
Getting Started Manual
922136-00 Rev A
61
B
Vertical
Overview
You can access Vertical settings using the front panel Vertical controls, by
selecting Vertical→ Channel Setup... on the menu bar, or by touching the
Channel trace descriptor label. The following screen-shot shows the C1
Vertical dialog on a LabMaster as an example. For each channel, a
corresponding Vertical dialog contains sections with respective controls.
1. Channel Controls
let you set up individual channels.
2. Actions for Trace C1 Buttons
let you perform certain
actions on the channel, such as Math, Zoom, and Measure actions.
3. Pre-Processing Controls
let you set up pre-process
controls, such as cable de-embedding and interpolation.
Channel Controls
The individual Channel Controls section of the dialog provides the following
functions for your respective channel:
Channel Inputs - For each channel, you can set the Channel Input to
either Input A (Upper) or Input B (Lower). The Channel Row LED
Indicators display which input is set for each channel.
PLEASE NOTE THE FOLLOWING:
Not all oscilloscope models have Upper and Lower Channel
Inputs. In those cases, no Selected Input buttons are
provided.
Slave Acquisition Modules indicate alternative, or B channels,
on named LED indicators.
Vertical Scale - For each channel, you can set the vertical scale or
sensitivity and choose whether to use fixed or variable gain
adjustment.
Vertical Offset - For each channel, you can select between zero
vertical offset or to set the offset to a specific value.