Teledyne LeCroy WaveRunner 6 Zi and 12-Bit HRO Getting Started Manual - Manual (Page 150)

WaveRunner 6 Zi and 12-Bit HRO
142 922136-00 Rev A
2. If recalling from Memory, touch inside the Source control and select
a source stored in non-volatile RAM (M1–M4) from the Select
Source pop-up.
3. Touch inside the Destination control and select a location for
storage (memory or file) from M1 to M4.
4. Show on Recall - Mark this checkbox to have the memory trace
shown on the grid display after recalling the waveform.
5. When saving a File, touch inside the Show only files control and
select an area to limit the search (channels, math functions, or
memory).
6. Touch inside the Recall files from directory data entry control and
provide the path. You can also touch the Browse button and
navigate to the file. Touch inside the Next file will be recalled from
data entry control and provide the path or, touch the Browse
button to navigate to the file.
7. Up /Down arrows - Use these buttons to cycles through files in the
selected folder from the Show only files control.
8. When finished, touch the Recall Now! button.