Teledyne LeCroy WaveRunner 6 Zi and 12-Bit HRO Getting Started Manual User Manual
Page 141
Getting Started Manual
922136-00 Rev A
133
B
PLEASE NOTE THE FOLLOWING: The flashback feature currently
recalls the DSO Setup, and all displayed waveforms. Some of result
data is not recalled, including:
Persistence data - While it is saved in hardcopy and is printed
on the report, it is not recalled during Flashback.
Histogram data - Histograms internally have a 32-bit
resolution, but when stored into a trace file and recalled
during flashback they are clipped to 16-bits.
Floating point waveforms - Certain math operations result in
the creation of floating point waveforms with much higher
resolution than can be stored in a 16-bit waveform file. This
extra resolution is not preserved when traces are recalled
using flashback.
Cumulative Measurements - Any measurements on when the
Lab Notebook entry is created are not saved individually in
the database (other than being embedded in the hardcopy
image). This means that when flashback is used, the
measurements are recomputed using the recalled waveform
data. Normally, this doesn't pose a problem; however, if
cumulative measurements were on when the entry was
stored and the cumulative measurements accumulated data
from multiple acquired waveforms, they lose their history and
show instead only the results from the stored waveforms.
4. You can use the Up and Down arrows to move through your My
Notebook Entries list one row at a time. If you have a large amount
of entries, touch the Filter button and the Filter Entries pop-up is
shown.
Provide a Date and/or Keyword and touch the Find Now button to
apply your filter to the My Notebook Entries list.
5. Use the View, Create Report, and E-Mail buttons as desired.
The View button shows a preview of your report.
Exit the preview by touching the Close button at the right of
the dialog.