E-mail – Teledyne LeCroy WaveRunner 6 Zi and 12-Bit HRO Getting Started Manual User Manual
Page 169
Getting Started Manual
922136-00 Rev A
161
B
Trigger → Acquisition Status
Math → Math Status, Zoom Status, or Memory Status
In addition to these dialogs, summaries are also provided for XY setups,
memory (M1-M4) setups, and time stamps for sequence mode sampling.
Before you can send e-mail from the oscilloscope, configurations must be
made on this dialog.
Numbered sections on this dialog correspond with the following
explanations.
1. On the E-Mail Server section of the dialog, choose a server protocol
from the following options:
MAPI (Messaging Application Programming Interface) is the
Microsoft interface specification that allows different
messaging and workgroup applications (including e-mail,
voice mail, and fax) to work through a single client, such as
the Exchange client. MAPI uses the default Windows e-mail
application.
SMTP (Simple Mail Transfer Protocol) is a TCP/IP protocol for
sending messages from one computer to another through a
network. This protocol is used on the Internet to route e-mail.
In many cases no account is needed.
2. Provide values on controls for SMTP Server, Originator Address
(From:), and Default Recipient Address (To:) on the Configuration
section of the dialog based the MAPI or SMTP choice during the
previous step.
If you chose MAPI, touch inside the Originator Address
(From:) data entry field and provide the instrument's e-mail
address. Then touch inside the Default Recipient Address
(To:) data entry field and provide the recipient's e-mail
address.