Teledyne LeCroy WaveRunner 6 Zi and 12-Bit HRO Getting Started Manual - Manual (Page 107)

Getting Started Manual
922136-00 Rev A 99
B
Measurement Parameters
Overview
Parameters are measurement tools that determine a wide range of
waveform properties. Use them to automatically calculate many attributes
of your waveform, like rise-time, rms voltage, and peak-to-peak voltage.
There are parameter modes for the amplitude and time domains, custom
parameter groups, and parameters for pass and fail testing. You can make
common measurements on one or more waveforms.
Turning On Parameters
1. Touch Measure → Measure Setup... on the menu bar.
2. Touch the On checkbox for each parameter you want to enable.
3. Touch the Show Table checkbox to display the parameters below
the grid.
Quick Access to Parameter Setup Dialogs
You can quickly gain access to a parameter
setup dialog by touching the parameter
table below the grid. For example, touch
within the P1 cell to display the P1 setup
dialog.
Touch the Measure cell to the far left to
display the main Measure dialog.