Teledyne LeCroy WaveRunner 6 Zi and 12-Bit HRO Getting Started Manual - Manual (Page 92)

WaveRunner 6 Zi and 12-Bit HRO
84 922136-00 Rev A
Display Setup
Access and adjust the different display configurations on our oscilloscope
using the following steps:
Note : Not all grid styles are available on all instruments. Grid styles vary based on
both oscilloscope model and whether or not you have the SDAII software option
loaded on your oscilloscope. Learn more about software options and
Contact
Teledyne LeCroy for Support .
1. Touch Display → Display Setup... on the menu bar.
2. Touch one of the Display combination buttons.
PLEASE NOTE THE FOLLOWING:

Small images label each Display combination button and indicate its
corresponding grid configuration.

Autogrid automatically adds or deletes grids as you select more or
fewer waveforms to display.

If more than a certain amount of display setups are available for
your oscilloscope, a Grid control is shown and presents the Select
Grid pop-up when touched.