Teledyne LeCroy WaveRunner 6 Zi and 12-Bit HRO Getting Started Manual - Manual (Page 177)

Getting Started Manual
922136-00 Rev A 169
B
EN 61000-4-11:2004 Mains Dips and Interruptions, 0%/1 cycle, 70%/25
cycles, 0%/250 cycles
4 5
1 To ensure compliance with all applicable EMC standards, high quality shielded
interface cables should be used.
2 Emissions which exceed the levels required by this standard may occur when the
oscilloscope is connected to a test object.
3 This product is intended for use in nonresidential areas only. Use in residential
areas may cause electromagnetic interference.
4 Meets Performance Criteria “B” limits of the respective standard: during the
disturbance, product undergoes a temporary degradation or loss of function or
performance which is self-recoverable.
5 Performance Criteria “C” applied for 70%/25 cycle voltage dips and for 0%/250
cycle voltage interruption test levels per EN61000-4-11.
European Contact:
Teledyne LeCroy Europe GmbH
Waldhofer Str 104
D-69123 Heidelberg
Germany
Tel: (49) 6221 82700
A
USTRALIA
& N
EW
Z
EALAND
D
ECLARATION
O
F
C
ONFORMITY
– EMC
Oscilloscope complies with the EMC provision of the Radio
Communications Act per the following standards, in accordance with
requirements imposed by Australian Communication and Media Authority
(ACMA):
CISPR 11:2003 Radiated and Conducted Emissions, Group 1, Class A, in
accordance with EN61326-1:2006 and EN61326-2-1:2006.
Australia / New Zealand Contacts:
Vicom Australia Ltd.
1064 Centre Road
Oakleigh, South Victoria 3167
Australia Vicom New Zealand Ltd.
60 Grafton Road
Auckland
New Zealand