Teledyne LeCroy WaveRunner 6 Zi and 12-Bit HRO Getting Started Manual - Manual (Page 14)

WaveRunner 6 Zi and 12-Bit HRO
6 922136-00 Rev A
Power
AC Power Source
100-240 VAC (+/-10%) at 50/60 Hz (+/-5%)
100-120 VAC (+/-10%) at 400 Hz (+/-5%)
Installation Category: 300V CAT II
Manual voltage selection is not required because the instrument
automatically adapts to line voltage.
Power Consumption
8-
BIT
M
ODELS
:
Power Consumption (Nominal): 425 Watts (425 VA)
Max Power Consumption (with all PC peripherals, active probes connected
to 4 channels, and MSO active): 500 Watts (500 VA)
12-
BIT
M
ODELS
:
Power Consumption (Nominal): 325 Watts (325 VA)
Max Power Consumption (with all PC peripherals, active probes connected
to 4 channels, and MSO active): 425 Watts (425 VA)
Power consumption in Standby Mode: 15 Watts
Power and Ground Connections
The instrument is provided with a 10A/250V 18AWG rated grounded cord
set containing a molded three-terminal polarized plug and a standard
IEC320 (Type C13) connector for making line voltage and safety ground
connections.
The AC inlet ground is connected directly to the frame of the instrument.
For adequate protection again electric shock, connect to a mating outlet
with a safety ground contact.
WARNING. Interrupting the protective conductor inside or outside
the oscilloscope, or disconnecting the safety ground terminal,
creates a hazardous situation. Intentional interruption is prohibited.