Teledyne LeCroy WaveRunner 6 Zi and 12-Bit HRO Getting Started Manual User Manual
Page 173
Getting Started Manual
922136-00 Rev A
165
B
Acronis True Image Echo Workstation
Note
: The following procedures cover basic steps for running the
True Image
Echo Workstation
. For more definitive documentation refer to their
aforementioned documentation resources.
Teledyne LeCroy provides you with a recovery application and a backup
image in an extra partition on the instrument's hard drive. The recovery
process is easy to perform, using the Recovery Wizard. After the recovery
procedure is done, you must activate Windows, either by Internet
connection to Microsoft's Web site or by telephone. Have your Windows
Product Key number (shown on a sticker on your oscilloscope) handy
during Widows reactivation.
Running the Acronis True Image Echo Workstation
Recovery Application
1. Connect a network cable to the LAN port on the rear of the
oscilloscope if you intend to activate windows through the Internet.
2. Connect a keyboard and a mouse to the oscilloscope.
3. Apply power to the oscilloscope.
4. As soon as the Starting Acronis Loader... Press F11 for Acronis
Startup Recovery Manager message appears on the screen, press
the F11 key until the recovery software logo appears momentarily.
The Acronis True Image Echo Workstation main window is
displayed.
Note
: Do not press
F11
before you see the
Starting Acronis Loader
message or you will enter the MB boot sequence selection.
5. Select Recovery from the Main Menu. The Restore Data Wizard
opens.
6. Click Next on the Welcome page.
7. On the Backup Archive Selection page, you choose the zone where
the recovery partition is located. Choose Acronis Secure Zone (this is
where the recovery data is located on your oscilloscope) and click
Next.