Teledyne LeCroy WaveRunner 6 Zi and 12-Bit HRO Getting Started Manual - Manual (Page 116)

WaveRunner 6 Zi and 12-Bit HRO
108 922136-00 Rev A
1. Touch inside the Source1 control and select an input waveform from
the Select Source window.
2. Touch inside the Measure field and select a parameter from the
Select Measurement window.
3. Touch the Histogram button at the bottom of the dialog. After
touching this button, the Math selection for Histogram pop-up is
shown. Select the desired Math Trace in which to store the results.
4. Touch the Close button when you are finished.
Touch the trace descriptor label for the math trace just created for the
results, and then touch the Histogram tab to access its right-hand dialog.
Numbered callouts on the previous image correspond with the following
explanations.
1. On the Buffer side of the Histogram right-hand dialog, touch
#Values and provide a value.
2. On the Scaling side of the Histogram right-hand dialog, touch #Bins
and provide a value.
3. Center the histogram by touching the Find Center and Width
button.
4. Instead of using the Find Center and Width button, you can provide
specific Center and Width values using their respective controls and
providing values using the pop-up numeric keypad.