beautypg.com

Pass/fail setup on qx dialogs, Getting started manual – Teledyne LeCroy WaveRunner 6 Zi and 12-Bit HRO Getting Started Manual User Manual

Page 123

background image

Getting Started Manual

922136-00 Rev A

115

B

When you have each of the Qx dialogs configured and enabled as desired,
you can then begin your testing and turn them all on or off using the
Testing checkbox on the main Pass/Fail dialog.

Your test data is shown on the Table display area shown in the previous
screen-shot.

Pass/Fail Setup on Qx Dialogs

The Qx dialog contains several controls for specifying your Pass/Fail setup.

M

AIN

Q

X

D

IALOG

C

ONTROLS

Use the Source1 control to specify the waveform you'll use for your
Condition.

Set your Pass/Fail condition by touching the Condition control on the
corresponding Qx dialog. The Pass/Fail Condition pop-up is shown.