Teledyne LeCroy WaveRunner 6 Zi and 12-Bit HRO Getting Started Manual User Manual
Page 37

Getting Started Manual
922136-00 Rev A
29
B
D
ECODE
When first pressing the Decode function button, the Serial Decode dialog is
shown. Subsequent presses of the Decode function button produce the
following results:
If you haven't enabled a Decode signal, it Closes the Serial Decode
dialog.
If you have enabled a Decode signal, it Closes the Serial Decode
dialog and disables the Decode signal.
If you have enabled a Decode signal, and the Serial Decode dialog is
closed or a different dialog is currently opened (say, the Zoom
dialog), the Serial Decode dialog is Opened.
Zoom and Table Buttons for Decode
The Zoom and Table buttons are used as described in The WavePilot
Control Area and The SuperKnob Overview
. Decode tables
are shown beneath the main display area.
W
AVE
S
CAN
When first pressing the WaveScan function button, the WaveScan dialog is
shown with table data showing in a column to the left of the main display
area. Subsequent presses of the WaveScan function button produce the
following results:
WaveScan is turned On and you click Close on the WaveScan dialog
or open a different dialog (say, the Zoom dialog), and then click the
WaveScan function button, the WaveScan dialog is Opened.
WaveScan is turned Off and the WaveScan dialog is Closed.
The Zoom and Table buttons are used as described in The WavePilot
Control Area and The SuperKnob Overview
.
H
ISTORY
When first pressing the History function button, the History dialog is
shown with table data showing in a column to the left of the main display
area. Subsequent presses of the History function button produce the
following results:
History is turned On and you click Close on the History dialog or
open a different dialog (say, the Zoom dialog), and then click the
History function button, the History dialog is Opened.