Status – Teledyne LeCroy WaveRunner 6 Zi and 12-Bit HRO Getting Started Manual User Manual
Page 152

WaveRunner 6 Zi and 12-Bit HRO
144
922136-00 Rev A
Maximize the application by touching the shortcut icon located on
the lower-right of the screen.
A sequence of calibration screens are shown when the Touch-Screen
Calibration button is touched. These screens instruct you to touch a
series of displayed crosses in order to improve precision and
accuracy when using your touch screen.
PLEASE NOTE THE FOLLOWING:
Use a stylus for this procedure. Using your finger for the
calibration prompts provides insufficient accuracy for the
procedure.
The calibration procedure times out after ten seconds pass
and no cross is touched.
Avoid parallax errors by placing your line of sight directly in
front of each cross before touching it.
The Service button is a section of the application reserved for
qualified Teledyne LeCroy personnel. When touched, an access code
pop-up is shown enabling Teledyne LeCroy technicians access to
various service dialogs inside the oscilloscope software.
Contact Teledyne LeCroy for more information using Contact
Teledyne LeCroy for Support.
Status
Control values are shown for information about your instrument. Among
them include your Hardware and Software options.
View the oscilloscope's system status (including software and hardware
configurations) on this Status dialog. The dialog displays read-only system
information including model number, serial number, firmware version,
and installed software and hardware options.