Actions for trace buttons, Annotating traces – Teledyne LeCroy WaveRunner 6 Zi and 12-Bit HRO Getting Started Manual User Manual
Page 48

WaveRunner 6 Zi and 12-Bit HRO
40
922136-00 Rev A
Trigger trace descriptor labels show the trigger mode (Auto, Normal, or
Stopped). It also shows the coupling (DC), trigger type (Edge), source (C1),
level (0 mV), and slope (Positive).
Setup information for horizontal cursors, including the time between
cursors and the frequency, is shown beneath the TimeBase and Trigger
trace descriptor labels.
Actions for Trace Buttons
You can access the same functions as the ones produced when using the
Signal Display Grid Pop-Up menu just by clicking a trace-descriptor label,
which shows its corresponding dialog. From the respective dialog, you're
able to access the same functions as Actions for Trace X buttons.
Open the Setup dialog for the trace.
Open the Math dialog for the trace.
Open the Measure dialog for the trace.
Annotate the selected trace.
For more information, see the Actions for Trace Buttons section of Dialog
Area
.
Annotating Traces
The instrument gives you the ability to add an identifying label, bearing
your own text, to a waveform display: