Teledyne LeCroy WaveRunner 6 Zi and 12-Bit HRO Getting Started Manual User Manual
Page 28
WaveRunner 6 Zi and 12-Bit HRO
20
922136-00 Rev A
Press the A
UTO
S
ETUP
... front panel button twice to perform the last
selection from the Auto Setup... flyout menu (the default is to
perform a full auto setup).
If Auto Setup is run when no channels are turned on, all channels are
affected. When more than one channel is turned on, the first
channel with a signal applied to it is automatically set up for edge
triggering.
Perform an autosetup of all these functions together by pressing the
Auto Setup... front panel button.
Clear Sweeps - Press to clear data from multiple sweeps
(acquisitions) including: persistence trace displays, averaged traces,
parameter statistics, and Histicons. During waveform readout,
cancels readout. This is the same as pressing Clear Sweeps on the
Measure → Measure Setup... or Math → Math Setup dialogs.
WaveStream - Indicates when WaveStream mode is ON. Refer to
WaveStream Mode
for more information.
Intensity - Press to toggle between WaveStream OFF and ON for
Analog Persistence and WaveStream ON for Color Persistence. When
you turn the knob, if WaveStream is ON, the WaveStream display
intensity changes. When you turn the knob, if WaveStream is OFF,
changes the Intensity setting. Corresponds with the screen menu
selection: Display → Display Setup
.