IAI America PSEL - Manual (Page 376)

366
Appendix
RCP2 Series Rod Type
RA2C Type
Current-limiting value (ratio, %)
P
u
sh
f
o
rce
(N)
High-speed type
Medium-speed type
Low-speed type
Current-limiting value (ratio, %)
P
u
sh
f
o
rce
(N)
Current-limiting value (ratio, %)
P
u
sh
f
o
rce
(N)
Current-limiting value (ratio, %)
P
u
sh
f
o
rce
(N)
Current-limiting value (ratio, %)
P
u
sh
f
o
rce
(N)
Current-limiting value (ratio, %)
P
u
sh
f
o
rce
(N)
Current-limiting value (ratio, %)
P
u
sh
f
o
rce
(N)
Current-limiting value (ratio, %)
P
u
sh
f
o
rce
(N)
Current-limiting value (ratio, %)
P
u
sh
f
o
rce
(N)
Caution
 The relationship of push force and current-limiting
value is based on the rated push speed (factory
setting) and provides only a guideline.
 Make sure the actual push force is equal to or greater
than the minimum push force. If not, the push force
will not stabilize.
 Do not change the setting of push speed (parameter
No. 7). If you must change the push speed, consult
IAI.
 If, among the operating conditions, the positioning
speed is set to a value equal to or smaller than the
push speed, the push speed will become the set
speed and the specified push force will not generate.
 Push Force and Current-limiting Value