IAI America PSEL - Manual (Page 14)

4
Part 1 Installation
Notes on Safety of Our Products
Common items you should note when performing each task on any IAI robot are explained below.
No. Task Note
1 Model
selection
 This product is not planned or designed for uses requiring high degrees of
safety. Accordingly, it cannot be used to sustain or support life and must not be
used in the following applications:
[1] Medical devices relating to maintenance, management, etc., of life or health
[2] Mechanisms or mechanical devices (vehicles, railway facilities, aircraft
facilities, etc.) intended to move or transport people
[3] Important safety parts in mechanical devices (safety devices, etc.)
 Do not use this product in the following environments:
[1] Place subject to flammable gases, ignitable objects, flammables,
explosives, etc.
[2] Place that may be exposed to radiation
[3] Place where the surrounding air temperature or relative humidity exceeds
the specified range
[4] Place subject to direct sunlight or radiated heat from large heat sources
[5] Place subject to sudden temperature shift and bedewing
[6] Place subject to corrosive gases (sulfuric acid, hydrochloric acid, etc.)
[7] Place subject to excessive dust, salt or iron powder
[8] Place where the product receives direct vibration or impact
 Do not use this product outside the specified ranges. Doing so may significantly
shorten the life of the product or result in product failure or facility stoppage.
2 Transportation  When transporting the product, exercise due caution not to bump or drop the
product.
 Use appropriate means for transportation.
 Do not step on the package.
 Do not place on the package any heavy article that may deform the package.
 When using a crane with a capacity of 1 ton or more, the crane must be
operated by personnel qualified to operate cranes and perform slinging
operations.
 When using a crane or other equipment, never use it to hoist any article
exceeding the rated load of the applicable crane, etc.
 Use hoisting accessories suitable for the article to be hoisted. Select appropriate
hoisting accessories by making sure there is an ample allowance for safety in
their cutting load, etc.
 Do not climb onto the article being hoisted.
 Do not keep the article hoisted.
 Do not stand under the hoisted article.
3 Storage/
preservation
 The storage/preservation environment should conform to the installation
environment. Among others, be careful not to cause bedewing.
4 Installation/
startup
(1) Installing the robot, controller, etc.
 Be sure to firmly secure and affix the product (including its work part).
If the product tips over, drops, malfunctions, etc., damage or injury may result.
 Do not step on the product or place any article on top. The product may tips over
or the article may drop, resulting in injury, product damage, loss of/drop in
product performance, shorter life, etc.
 If the product is used in any of the following places, provide sufficient shielding
measures:
[1] Place subject to electrical noise
[2] Place subject to a strong electric or magnetic field
[3] Place where power lines or drive lines are wired nearby
[4] Place subject to splashed water, oil or chemicals