Planet Technology IP DSLAM IDL-4801 - Manual (Page 71)

IP DSLAM 71
Bert Sync Indicates whether the Signal is in Sync or not.
Select Information Valid Indicates the information validity for the SELT operation conducted on the Xcvr.
Select Loop Length
Indicates the LOOP Length in Feet once when the SELT information is valid on
the Xcvr.
Select Loop End
Indicates whether the loop is short or open once when the SELT information is
valid on the Xcvr.
Select Loop Gauge
Indicates the LOOP wire gauge information once, when the SELT information is
valid on the Xcvr.
Select the port ID from the DSL Port drop-down list to view a specified DSL’s physical Layer
Info. Click on to close the window.
3.9.2 Channel Layer Info
Allow users to view the Channel layer information of a specified DSL port from the IP
DSLAM. Double Click on “Channel Layer Info” from the Function List Window. The
Channel Layer Info window appears.
Field Definition
Interleave delay Interleave delay for this channel. (milli-seconds)
Previous TX rate Previous actual transmit rate on this channel if ADSL loop retain. (kbps)
Current TX rate Actual transmit rate on this channel. (kbps)
CRC block length The length of the channel data-block on which the CRC operates.
Current Atm Status Indicates the current ATM Status.
Rs Symbols
Indicates the number of DMT symbols per Reed-Solomon code word (S),
in the downstream direction.
Rs Depth Indicates interleaving depth (D), in the downstream direction.
Rs Redundency
Indicates the number of redundant bytes (R), per Reed-Solomon code in
the downstream direction
Select the port ID from the DSL Port drop-down list view a specified DSL’s channel Layer
Info. Click on to close the window.