Planet Technology IP DSLAM IDL-4801 - Manual (Page 389)

IP DSLAM 389
subrules is all ANDed.
Action Value The parameter should contain valid value for some actions that
require an additional input, other than setprio, retagprio, and
retagserviceprio actions. For sendtocontrol and copytocontrol
actions this parameter should contain control flow id (0-3). Other
values are invalid for this action. For modifytos action this
parameter should contain value to be set in TOS field in the packet
in the range 0 to 255. Other values are invalid for this action. The
application of this value is dependent on the mask parameter. For
setbaclevel action this parameter should contain valid Buffer
Admission Control level value of 0 or 1. For pktvlanid, retagvlanid,
pktservicevlanid and retagservicevlanid actions this parameter
should be filled with VLAN ID value in the range 1 to 4094. For
ratelimiter action this parameter should be filled with the valid
user-defined flow type value. For mirror action this parameter
should be filled with valid mirror context id. This parameter is
ignored for other actions. Specifying an invalid value for an action
would result in error when the rule is enabled.
Action Mask This field is valid for sendtocontrol, copytocontrol and modifytos
actions only. For sendtocontrol and copytocontrol actions this
parameter should contain trap level 0xffffffff (trap disabled) or
0x00000000(trap enabled). Other values are invalid for this action.
For modifytos action, only lower 8-bits are taken into consideration
and other bits are ignored. In the mask if a bit location contains 1,
then the corresponding bit in the TOS field is overwritten with the
corresponding bit in action value. In the mask if a bit location
contains 0, then the corresponding bit in the TOS field remains
unchanged.
5.13.22 Filter rule map Commands
5.13.22.1 Get Filter rule map
Description:
Use this command to get.
Command Syntax:
get filter rule map [ifname | all | alleoa | alleth | allpppoe |
allcpe | allipoe] [stageid ] [ruleid ]